Satellite IoT in Europe: Why 868 MHz Falls Short for Global Products
Anyone who wants to connect an IoT product for the global market via satellite will not get far with LoRaWAN in the 868 MHz band. The European rule for it applies in only six countries so far, and it describes the link from satellite to device only for wake-up calls and control commands. NB-NTN, i.e. NB-IoT via satellite, transmits in both directions and follows a global standard, but it too requires spectrum rights.
- A European rule for satellite communication in the 868 MHz band has applied since June 2025, but by November 2026 only six countries had implemented it, including Germany.
- For the link from satellite to device, the European 868 MHz rule describes only broadcasts for wake-up calls and control commands, which is why antenna specialist Harald Naumann considers firmware updates practically ruled out.
- NB-NTN, the satellite variant of the NB-IoT mobile standard, transmits in both directions and is offered by Deutsche Telekom, Vodafone and o2 Telefónica, but it too requires spectrum rights in every country.
Satellite IoT has become a commercial race. The radio technology a manufacturer chooses today decides success: either the connected product can be sold worldwide, or it becomes an expensive risk, in certification as well as in operation. 868 MHz is a European band. In North and South America, the comparable license-free band lies at 902 to 928 MHz. Anyone who wants to sell worldwide therefore needs several bands and certifications. Europe adds another hurdle: devices in the 868 MHz band may communicate with satellites in only a few countries.
What does Europe allow in the 868 MHz band?
Europe reserves the band from 862 to 870 MHz for short range devices (SRD), i.e. low-power radio devices such as sensors, wireless switches or LoRaWAN nodes. LoRaWAN is a radio protocol for wide area networks that gets by on very little energy. The band has no allocation for satellite services. That is why CEPT created a special rule. CEPT is the European Conference of Postal and Telecommunications Administrations.
Its Electronic Communications Committee (ECC) adopted Decision ECC/DEC/(25)02 on June 27, 2025. It sets out the technical conditions under which low-power devices may communicate with satellites. So far, the list in the annex to the decision contains two satellite systems: LS-4 from Lacuna Space, notified by Germany, and Plan-S from Connecta IoT, notified by Türkiye. What matters is whether a country adopts the rule. That does not happen automatically.
According to the CEPT implementation database, six countries have implemented the decision: Belgium, Denmark, Germany, Lithuania, Slovakia and Spain. Eleven more plan to do so, including France and the Netherlands. Sixteen are still examining it. Poland, Serbia and the United Kingdom have not implemented the rule. In Germany, the Federal Network Agency (Bundesnetzagentur) must authorize each satellite network individually. As with terrestrial LoRa, the device itself needs CE marking under the European Radio Equipment Directive (RED). In the simplest case, a self-declaration by the manufacturer is sufficient. That does not replace a look at the market. Anyone who wants to supply further countries must answer two questions: Has the country implemented the rule? And does the satellite operator hold an authorization there? Approval in one country does not apply to the whole of ITU Region 1, which covers Europe, Africa and the Middle East.
Why is an uplink not enough for many applications?
Classic LoRaWAN uses wideband LoRa modulation, typically on eight channels of 125 kHz each. That consumes valuable spectrum. Then there is the access method. LoRaWAN works on the ALOHA principle: devices transmit without first checking whether the channel is free. The protocol accepts collisions and packet loss. Fast-moving satellites, short visibility windows and the Doppler shift, i.e. the frequency change caused by the satellite’s motion, make transmission in orbit even less reliable. For tracking goods, agriculture or infrastructure monitoring, a lost message can mean lost revenue.
Semtech developed a frequency-hopping method for LoRaWAN called LR-FHSS. It is narrowband and uses spectrum more sparingly. It does not change the ALOHA principle. LoRaWAN remains LoRaWAN, with the familiar collisions. The bigger limitation lies in the downlink, the radio link from satellite to device. The ECC decision describes these transmissions as multicast messages, i.e. transmissions to many devices at once, for wake-up calls or device control. According to the decision, such systems typically do not use targeted transmissions to individual devices. In addition, the decision strictly limits how much transmit power may reach the ground.
Under these conditions, I consider firmware updates over the air, FOTA for short, practically ruled out. That is enough for a sensor that occasionally sends readings. Devices that need updates or must communicate reliably in both directions need a different path.
What does NB-NTN offer instead?
NB-IoT is a mobile communications standard for energy-saving IoT devices. With Release 17, the standardization body 3GPP opened NB-IoT to non-terrestrial networks (NTN), i.e. to satellites. The devices determine their position via satellite navigation (GNSS) and compensate for time and frequency offsets themselves. This lets them cope with the long signal delay and the Doppler effect. People also often speak of 5G NTN. More precisely, the industry distinguishes two variants: NB-NTN, i.e. NB-IoT via satellite, and NR-NTN, the satellite variant of 5G NR.
Since Release 19, NR-NTN also serves RedCap and eRedCap devices. These are simplified 5G devices for IoT applications that transmit more data than an NB-IoT sensor. Unlike with ALOHA, the network assigns transmission times to the devices. Data flows in both directions. And it travels over satellite bands intended for this service, not over a borrowed band for short-range radio. Skylo, for example, does not operate its own satellites.
The provider transmits in L-band (n255) and S-band (n256) via the satellites of partners such as Viasat and EchoStar. The ecosystem is growing. Chipsets, modules, certification programs and network operators are ready. Since August 2024, Pixel 9 owners have been able to reach emergency services by satellite via Skylo, now also with the Pixel 10 series. For IoT devices, besides Deutsche Telekom, o2 Telefónica and Vodafone IoT also offer NB-NTN via Skylo.
What hurdles does NB-NTN face as well?
NB-NTN needs authorizations too. The satellite operator must hold the rights to its frequencies in every country. Providers are at different stages. At Deutsche Telekom, Skylo is in live operation with geostationary satellites, while the connection of OQ Technology with satellites in low Earth orbit has been validated. Geostationary satellites stay above a fixed point on Earth. Satellites in low Earth orbit, LEO for short, circle the Earth at an altitude of a few hundred kilometers.
The licensed route for LoRa has an expiry date. EchoStar Mobile offers satellite LoRaWAN mainly in the licensed S-band, outside the 868 MHz rules. The European rights in this 2 GHz band are held by EchoStar and Viasat. They expire in May 2027. After that, the European Commission wants to reassign the band EU-wide. For the transition period, the existing rights are to remain valid for two more years under a Commission proposal. During this time, the holders may neither transfer nor lease them.
What matters in antenna design?
With geostationary satellites, such as those Skylo uses, the base station is around 36,000 kilometers away. Over this distance, a small error in the antenna design is enough, and the device fails to establish a connection. Satellites in low orbit are closer but move quickly across the sky. There, Doppler shift and signal delay change quickly. On top of that come hurdles in the device itself: limited space for the antenna and the question of how well it performs in the finished housing.
An open example of this is the OpenFlare project. My company Antennity is developing it with its partner Embever on behalf of the European Space Agency (ESA). OpenFlare is a connected, open-source warning light for the roadside, intended to replace the warning triangle. At the same time, it serves as an open reference platform for battery-powered IoT devices that need to know their position precisely. The device communicates via NB-IoT and LTE-M, switches to satellites via NB-NTN in coverage gaps and determines its position via GNSS. Wherever possible, the team publishes the development steps openly: from schematics and antenna concepts to RF measurements.
Where is NB-NTN already in use?
One example is the livestock tracking collar from the Spanish manufacturer Digitanimal. It transmits via NB-NTN to satellites over Skylo’s network. Skylo has certified the device for its network. Digitanimal is a customer of Antennity. My team developed the hardware, Digitanimal the firmware. The collar contains a PrimeLoop antenna instead of a classic chip antenna.
Conclusion
The 868 MHz band is suitable for sensors that occasionally send readings and operate in one of the countries that have implemented the CEPT rule. Anyone who wants to sell worldwide, needs firmware updates or must communicate in both directions is better off with NB-NTN. The standard is in place; chipsets, modules and network operators are available. NB-NTN is still a very small market. And the standard route, too, depends on spectrum rights that Europe is currently reorganizing. Anyone planning a satellite product should therefore check every target market before committing to a platform.
According to the CEPT implementation database, Belgium, Denmark, Germany, Lithuania, Slovakia and Spain have implemented Decision ECC/DEC/(25)02 (as of November 2026). Eleven more countries plan to do so, including France and the Netherlands. In Germany, the Federal Network Agency must authorize each satellite network individually.
CEPT Decision ECC/DEC/(25)02 keeps a list of satellite systems that meet its technical conditions. So far it contains two systems: LS-4 from Lacuna Space, notified by Germany, and Plan-S from Connecta IoT, notified by Türkiye.
Hardly, in the European 868 MHz band. The CEPT decision describes transmissions from satellite to device as broadcasts for wake-up calls or control commands and strictly limits how much transmit power may reach the ground. Under the concept it describes, this downlink is not intended for larger data volumes such as firmware updates.
NB-NTN, also called NB-IoT NTN, is the satellite variant of the NB-IoT mobile standard for energy-saving IoT devices. With Release 17, the standardization body 3GPP opened NB-IoT to satellite networks, known as non-terrestrial networks (NTN). The devices communicate in both directions and use satellite bands such as L-band and S-band.
NB-NTN brings the energy-saving NB-IoT mobile standard via satellite to devices that send little data. NR-NTN is the satellite variant of 5G NR. Since Release 19, NR-NTN also serves RedCap and eRedCap devices, i.e. simplified 5G devices for IoT applications with higher data requirements.
The European rights in the 2 GHz band for mobile satellite services are held by EchoStar and Viasat and expire in May 2027. The European Commission then wants to reassign the band EU-wide. For the transition period, the existing rights are to remain valid for two more years under a Commission proposal, without the holders being allowed to transfer or lease them.













